action session-up
To configure what action is taken on an interface when an Ethernet OAM session is established, use the action
session-up command in Ethernet OAM configuration mode or interface Ethernet OAM configuration mode.
To return to the default, use the no form of this command.
action session-up {disable| log}
no action session-up {disable| log}
Syntax Description
Performs no action on the interface when an Ethernet OAM session is established.disable
(Interface Ethernet OAM configuration only) Creates a syslog entry when an Ethernet
OAM session is established. This action is available only in interface Ethernet OAM
configuration mode to override the OAM profile on a specific interface.
log
Command Default
The default action is to create a syslog entry.
Command Modes
Ethernet OAM configuration (config-eoam)
Interface Ethernet OAM configuration (config-if-eoam)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to configure that no action is performed on the interface when an Ethernet
OAM session is established.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
149
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
action session-up
To Next Page
Loading...
Need help?
General
