multilink group
To attach a serial interface to a multilink interface bundle, use the multilink group command in interface
configuration mode. To remove a serial interface from a multilink interface bundle, use the no form of this
command.
multilink group bundleID
no multilink group bundleID
Syntax Description
Bundle ID number of the multilink interface, in the format
rack/slot/bay/controllerID/bundleID)
bundleID
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writehdlc
Examples
The following examples show how to attach a serial interface to a multilink interface bundle:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface serial 0/1/0/1/1/1:0
RP/0/RSP0/CPU0:router(config-if)# multilink group 1
RP/0/RSP0/CPU0:router(config-if)# commit
or
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface serial 0/1/0/1/1/1:0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
685
Multilink Commands on the Cisco ASR 9000 Series Router
multilink group
To Next Page
Loading...
Need help?
General
