Cisco ASR 9000 Series - Page 704

The following example shows how to set the multilink fragment delay:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface multilink 0/1/0/0/1
RP/0/RSP0/CPU0:router(config-if)# multilink fragment delay 2
RP/0/RSP0/CPU0:router(config-if)#
Related Commands
DescriptionCommand
Configures a multilink interface and enters multilink interface
configuration mode.
interface multilink, on page 680
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
684
Multilink Commands on the Cisco ASR 9000 Series Router
multilink fragment