pm optics report enable
To enable Threshold Crossing Alert (TCA) generation on the optics layer, use the pm optics report enable
command in DWDM configuration mode. To disable TCA reporting, use the no form of this command.
pm {15-min| 24-hour} optics report {lbc| opr| opt} {max-tca| min-tca} enable
no pm {15-min| 24-hour} optics report {lbc| opr| opt} {max-tca| min-tca} enable
Syntax Description
Configures TCA generation for 15-minute intervals.15-min
Configures TCA generation for 24-hour intervals.24-hour
Laser bias current.lbc
Optical power on the unidirectional port.opr
Transmit optical power in dBm.opt
Indicates that the maximum value of the parameter is compared against the
threshold to determine if a TCA should be generated.
max-tca
Indicates that the minimum value of the parameter is compared against the
threshold to determine if a TCA should be generated.
min-tca
Command Default
TCA reporting is not enabled.
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To display performance monitoring information for the optics, use the show controller dwdm pm optics
command.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
36
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
pm optics report enable
To Next Page
Loading...
Need help?
General
