Cisco ASR 9000 Series - Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference

-------------------- --------------- ----------- -------------- -----------
Gi0/0/0/2 Local Active 0x8000, 0x0002 100000
Table 39: show bundle Field Descriptions
DescriptionField
Full name of the bundle interface, where type is Ether
(Ethernet) , followed by the configured number of
the bundle.
Bundle-typenumber
State of the bundle on the local device, with one of
the following possible values:
• Admin down—The bundle has been configured
to be shut down.
• Bundle shut—The bundle is holding all links in
Standby state and will not support any traffic.
• Down—The bundle is operationally down. It
has no Active members on the local device.
• mLACP cold standby—The bundle is acting as
a multichassis LACP Standby device, but the
higher layers are not synchronized.
• mLACP hot standby—The bundle is Up on the
mLACP peer device, and the local device is
ready to take over if that bundle goes down on
the peer.
• Nak—The local and peer devices cannot resolve
a configuration error.
• Partner down—The partner system indicates
that the bundle is unable to forward traffic at its
end.
• PE isolated—The bundle is isolated from the
core.
• Up—The bundle has Active members on this
device.
Status:
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
621
Link Bundling Commands on the Cisco ASR 9000 Series Router
show bundle