Cisco ASR 9000 Series Command Reference Guide

ssrp location
To specify the node on which to create a Session State Redundancy Protocol (SSRP) group and enter the
SSRP node configuration mode, use the ssrp location command in global configuration mode.
ssrp location node_id
Syntax Description
Specifies the full qualified path of a specific node in the format rack/slot/module.node_id
Command Default
No default behavior or values
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The location specifies the card on which an SSRP group is created.
Task ID
OperationsTask ID
read, writeppp
Examples
This example shows how to create an SSRP group on a specified node for use by any interface on the card:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# ssrp location 0/1/cpu0
RP/0/RSP0/CPU0:router(config-ssrp-node)#
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
773
PPP Commands onthe Cisco ASR 9000 Series Router
ssrp location

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model