show lacp port
To display detailed information about Link Aggregation Control Protocol (LACP) ports, enter the show lacp
port command in EXEC mode.
show lacp port [[GigabitEthernet| TenGigE] interface_instance]
Command Default
No default behavior or values.
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readbundle
Examples
The following example shows how to display LACP port information for all link bundles on a router:
RP/0/RSP0/CPU0:router# show lacp port
Flags: A - Device is in Active mode. P - Device is in Passive mode.
S - Device sends PDUs at slow rate. F - Device sends PDUs at fast rate.
D - Port is using default values for partner information
E - Information about partner has expired
State: 0 - Port is Not Aggregatable. 1 - Port is Out Of Sync with peer.
2 - Port is In Sync with peer. 3 - Port is Collecting.
4 - Port is Collecting and Distributing.
Bundle-Ether1
Minimum active Maximum active
B/W (Kbps) MAC address Links B/W (Kbps) Links
---------- -------------- ----- ---------- -----
0 0800.453a.651d 1 620000 32
Port State Flags Port ID Key System-ID
------------ ----- ----- -------------- ------ -------------------------
Gi0/0/2/0 1 ASDE 0x8000, 0x0001 0x0001 0x8000, 08-00-45-3a-65-01
PEER 0 PSD 0xffff, 0x0000 0x0000 0xffff, 00-00-00-00-00-00
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
656
Link Bundling Commands on the Cisco ASR 9000 Series Router
show lacp port
To Next Page
Loading...
