path (SONET)
To enter SONET/SDH path configuration mode, use the path command in SONET controller configuration
mode.
path
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
SONET controller configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to access SONET path submode from SONET controller configuration
mode:
RP/0/RSP0/CPU0:router(config)# controller sonet 0/1/0/0
RP/0/RSP0/CPU0:router(config-sonet)# path
Related Commands
DescriptionCommand
Enables automatic insertion of PAIS in the sent SONET signal
whenever the SONET path enters the administratively down state.
ais-shut (SONET path), on page 837
Enables sending of a PRDI when the BER bit interleaved parity
(BIP) B3 threshold is exceeded.
b3-ber-prdi, on page 848
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
884
SONET Controller Commands on the Cisco ASR 9000 Series Router
path (SONET)
To Next Page
Loading...
Need help?
General
