show ethernet cfm interfaces ais
To display the information about interfaces that are currently transmitting Alarm Indication Signal (AIS), use
the show ethernet cfm interfaces ais command in EXEC mode.
show ethernet cfm interfaces [type interface-path-id] ais [location node-id]
Syntax Description
(Optional) Interface type. For more information, use the question mark (?) online
help function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
(Optional) Displays information about the node location specified as rack / slot /
module. Location cannot be specified if you configure an interface type.
location node-id
Command Default
If no parameters are specified, information for all AIS interfaces is displayed.
Command Modes
EXEC (#)
Command History
ModificationRelease
This command was introduced.Release 3.9.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The location keyword cannot be specified if an interface has been specified.Note
Task ID
OperationsTask ID
read, writeethernet-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
324
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
show ethernet cfm interfaces ais
To Next Page
Loading...
Need help?
General
