redundancy iccp group
To configure Inter Chassis Communication Protocol (ICCP) parameters, use the redundancy iccp group
command in the global configuration mode. To return to the default, use the no form of this command.
redundancy iccp group group-id
no redundancy iccp group group-id
Syntax Description
Specifies ICCP group ID.
group-id
Command Default
ICCP redundancy is disabled.
Command Modes
Global configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeconfig-services
Examples
The following example shows how to configure ICCP parameters:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# redundancy iccp group 10
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)#
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
617
Link Bundling Commands on the Cisco ASR 9000 Series Router
redundancy iccp group
To Next Page
Loading...
