show controllers (Ethernet)
To display status and configuration information about the Ethernet interfaces on a specific node, use the show
controllers command in EXEC mode.
show controllers {GigabitEthernet| TenGigE} interface-path-id [all| bert| internal| mac| phy| stats| xgxs]
Syntax Description
Specifies the type of Ethernet interface whose status and configuration
information you want to display. Enter GigabitEthernet or TenGigE.
{GigabitEthernet |
TenGigE}
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
Displays detailed information for the specified interface.all
Displays BERT status information for the interface.bert
Displays internal information for the interface.internal
Displays mac information for the interface.mac
Displays physical information for the interface.phy
Displays statistical information for the interface.stats
Displays information about the 10 Gigabit Ethernet Extended Sublayer (XGXS).xgxs
Command Default
No default behavior or values
Command Modes
EXEC mode
Command History
ModificationRelease
This command was first introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
105
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
show controllers (Ethernet)
To Next Page
Loading...
Need help?
General
