Cisco ASR 9000 Series Command Reference Guide

The G.709 wrapper must be enabled to enable forward error correction (FEC) mode on the controller.
Standard FEC is the default mode; therefore, if you use the no g709 fec command, standard FEC is used.
To display the FEC mode, use the show controller dwdm command.
Task ID
OperationsTask ID
read, writedwdm
Examples
This example shows how to configure the FEC mode on a DWDM controller:
RP/0/RSP0/CPU0:router(config)# controller dwdm 0/6/0/0
RP/0/RSP0/CPU0:router(config-dwdm)# admin-state out-of-service
RP/0/RSP0/CPU0:router(config-dwdm)# commit
RP/0/RSP0/CPU0:router(config-dwdm)# g709 fec standard
RP/0/RSP0/CPU0:router(config-dwdm)# commit
RP/0/RSP0/CPU0:router(config-dwdm)# admin-state in-service
RP/0/RSP0/CPU0:router(config-dwdm)# commit
Related Commands
DescriptionCommand
Configures the transport administration state on a DWDM port.admin-state, on page 3
Displays optical parameters, G.709 alarms and counters, and
register and module information for a DWDM controller.
show controller dwdm, on page 56
Inserts a GAIS pattern to client on the detection of a BDI.g709 bdi-to-client-gais, on page 7
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
10
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
g709 fec

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model