Cisco ASR 9000 Series - Width

width
To set the number of paths in a stream, use the width command in the STS or AU controller configuration
mode.
width number
Syntax Description
Number of STS streams that are concatenated. The possible values are:
• 1—Indicating one STS stream
• 3—Indicating three STS streams (STS-3c)
• 12—Indicating concatenation of 12 STS streams (STS-12c)
• 48—Indicating concatenation of 48 STS streams (STS-48c)
Widths 3, 12, and 48 are configured on STS paths at natural boundaries, which coincide with
the following path numbers:
•
1, 4, 7, 10, and so on, for STS-3c
•
1, 13, 25, and 37 for STS-12c
•
1 for STS-48c
number
Command Default
The default is 1.
Command Modes
SONET controller configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writesonet-sdh
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
932
SONET Controller Commands on the Cisco ASR 9000 Series Router
width