Cisco ASR 9000 Series Command Reference Guide

admin-state
To configure the transport administration state on a DWDM port, use the admin-state command in DWDM
configuration mode. To return the administration state from a DWDM port to the default, use the no form of
this command.
admin-state {in-service| out-of-service}
no admin-state {in-service| out-of-service}
Syntax Description
Places the DWDM port in In Service (IS) state, to support all normal operation.in-service
Places the DWDM port in Out of Service (OOS) state. The laser is turned off
and all traffic flow is stopped. This is the default.
out-of-service
Command Default
Out-of-service is the default transport administration state.
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
When you configure admin-state out-of-service, the DWDM port is placed in OOS state. The laser is turned
off, traffic flow is stopped, and proactive protection is disabled. However, configuration changes can still be
made on the port.
Task ID
OperationsTask ID
read, writedwdm
Examples
The following example shows how to turn on the laser and place a DWDM port in In Service (IS) state:
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
3
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
admin-state

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model