pm fec threshold
To configure performance monitoring thresholds on the FEC layer, use the pm fec threshold command in
DWDM configuration mode. To return to the default state, use the no form of this command.
pm {15-min| 24-hour} fec threshold {ec-bits| uc-words} threshold
no pm {15-min| 24-hour}fec threshold {ec-bits| uc-words} threshold
Syntax Description
Configures the performance monitoring thresholds for 15-minute intervals.15-min
Configures performance monitoring thresholds for 24-hour intervals.24-hour
Bit errors corrected (BIEC). Indicates the number of bit errors corrected in the
DWDM trunk line during the performance monitoring time interval.
ec-bits
Uncorrectable Words. This is the number of uncorrectable words detected in the
DWDM trunk line during the performance monitoring time interval.
uc-words
Threshold for the performance monitoring parameter in the range 1–4294967295.
threshold
Command Default
No threshold is configured.
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To display performance measurement information for the FEC layer, use the show controller dwdm pm fec
command.
Task ID
OperationsTask ID
read, writedwdm
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
34
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
pm fec threshold
To Next Page
Loading...
Need help?
General
