Cisco ASR 9000 Series Command Reference Guide

Examples
The following example shows how to display all the CFM configuration errors on all domains:
RP/0/RSP0/CPU0:router# show ethernet cfm configuration-errors
Domain fig (level 5), Service bay
* MIP creation configured using bridge-domain blort, but bridge-domain blort does not
exist.
* An Up MEP is configured for this domain on interface GigabitEthernet0/1/2/3.234 and an
Up MEP is also configured for domain blort, which is at the same level (5).
* A MEP is configured on interface GigabitEthernet0/3/2/1.1 for this domain/service, which
has CC interval 100ms, but the lowest interval supported on that interface is 1s.
Related Commands
DescriptionCommand
Enters CFM configuration mode.ethernet cfm (global), on page 207
Enters interface CFM configuration mode.ethernet cfm (interface), on page 209
Sends Ethernet CFM traceroute messages to generate a
basic.
traceroute ethernet cfm, on page 415
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
323
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
show ethernet cfm configuration-errors

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model