bundle minimum-active bandwidth
To set the minimum amount of bandwidth required before a user can bring up a specific bundle, use the bundle
minimum-active bandwidth command in interface configuration mode.
bundle minimum-active bandwidth kbps
Syntax Description
Minimum bandwidth required before you can bring up a bundle. Range is from 1 through
a number that is equivalent to the combined bandwidths of 8 TenGigabitEthernet interfaces
.
kbps
Command Default
The default setting is kbps = 1.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writebundle
Examples
This example shows how to set the minimum amount of bandwidth required before a user can bring up a
specific bundle. In this example, the user sets the minimum amount of bandwidth required to bring up Ethernet
bundle 1 to 620000:
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 1
RP/0/RSP0/CPU0:router(config-if)# bundle minimum-active bandwidth 620000
Related Commands
DescriptionCommand
Displays information about configured bundles.show bundle, on page 619
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
580
Link Bundling Commands on the Cisco ASR 9000 Series Router
bundle minimum-active bandwidth
To Next Page
Loading...
Need help?
General
