Cisco ASR 9000 Series - Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference

Examples
The following example shows how to configure the low and high thresholds that trigger a frame error event:
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# link-monitor
RP/0/RSP0/CPU0:router(config-eoam-lm)# frame threshold low 100 high 60000
Related Commands
DescriptionCommand
Creates an EOAM profile and enters EOAM configuration
mode.
ethernet oam profile, on page 215
Enters Ethernet OAM link monitor configuration mode.link-monitor, on page 262
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
257
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
frame threshold