Cisco ASR 9000 Series - Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference

Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to create an SLA operation instance using a profile named “Profile_1” to
a destination MEP with the specified MAC address:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# ethernet cfm
RP/0/RSP0/CPU0:router(config-if-cfm)# mep domain Dm1 service Sv1 mep-id 1
RP/0/RSP0/CPU0:router(config-if-cfm-mep)# sla operation profile Profile_1 target mac-address
01:23:45:67:89:ab
Related Commands
DescriptionCommand
Displays information about maintenance end points (MEPs)
for peer MEPs.
show ethernet cfm peer meps, on page 339
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
399
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
sla operation