Cisco ASR 9000 Series Command Reference Guide

lacp collector-max-delay
To configure the maximum period of wait time between sending of two subsequent Ethernet frames on a link,
enter the lacp collector-max-delay command in interface configuration mode. To return to the default, use
the no form of this command.
lacp collector-max-delay delay-in-tens-of-microseconds
no lacp collector-max-delay delay-in-tens-of-microseconds
Syntax Description
Length of wait time, in tens of microseconds. The range is from 0
to 65535. The default is 0xFFFF.
delay-in-tens-of-microseconds
Command Default
The collector-max-delay time is not configured.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 5.1.3
Task ID
OperationTask ID
read, writebundle
Examples
The following example shows how to configure the maximum period of wait time between sending of two
subsequent Ethernet frames on a link:
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 100
RP/0/RSP0/CPU0:router(config-if)# lacp collector-max-delay 500
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
595
Link Bundling Commands on the Cisco ASR 9000 Series Router
lacp collector-max-delay

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model