Cisco ASR 9000 Series Command Reference Guide

Examples
The following example shows how to create a MEP using an ID of 1 on the CFM domain named DM1 and
service named Sv1:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# ethernet cfm
RP/0/RSP0/CPU0:router(config-if-cfm)# mep domain Dm1 service Sv1 mep-id 1
Related Commands
DescriptionCommand
Enters interface CFM configuration mode.ethernet cfm (interface), on page 209
Displays information about errors that are preventing configured
CFM operations from becoming active, as well as any warnings
that have occurred.
show ethernet cfm configuration-errors, on
page 322
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
280
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
mep domain

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model