Specifies the time between sending
packets in a burst, where number
is in the following range:
•
100 to 30000 milliseconds
•
1 to 30 seconds
The total length of a burst
(the packet count
multiplied by the interval)
must not exceed 1 minute.
Note
interval number {milliseconds | seconds}
Minimum size of the packet
including padding when necessary.
The range is 1 to 9000 bytes. This
value is the total frame size
including the Layer 2 or Layer 3
packet header.
packet sizebytes
(Optional) Specifies a 4-byte string
(8 hexadecimal characters) to
repeat as many times as required to
fill the outgoing probe packet to the
specified minimum packet size. The
default is all 0s.
test pattern hex 0x HHHHHHHH
Specifies the name of the domain
for the locally defined CFM MEP.
domain domain-name
Specifies the source interface type
of the locally defined CFM MEP.
For more information, use the
question mark (?) online help
function.
source interface type
Physical interface or virtual
interface.
Use the show interfaces
command to see a list of
all interfaces currently
configured on the router.
Note
For more information about the
syntax for the router, use the
question mark (?) online help
function.
interface-path-id
Specifies the MAC address (in
dotted hexadecimal format) of the
target MEP that is known to the
local MEP for the probe.
target mac-address H.H.H
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
226
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet sla on-demand operation type cfm-delay-measurement probe
To Next Page
Loading...
Need help?
General
