Cisco ASR 9000 Series Command Reference Guide

network connection id
To configure a connection identifier for the Multi Service Transport Protocol (MSTP), use the network
connection id command in DWDM configuration mode. To remove a connection identifier, use the no form
of this command.
network connection id id-number
no network connection id id-number
Syntax Description
Connection identifier.id-number
Command Default
No default behavior or values
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writedwdm
Examples
The following example shows how to configure a connection identifier for the Multi Service Transport Protocol
(MSTP).
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# controller dwdm 0/1/0/1
RP/0/RSP0/CPU0:router(config-dwdm)# network connection id 1/1/1/1
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
28
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
network connection id

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model