log continuity-check errors
To enable logging of continuity-check errors, use the log continuity-check errors command in CFM domain
service configuration mode. To disable logging of continuity-check errors, use the no form of this command.
log continuity-check errors
no log continuity-check errors
Syntax Description
This command has no keywords or arguments.
Command Default
Logging is disabled.
Command Modes
CFM domain service configuration (config-cfm-dmn-svc)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The following types of continuity-check errors are logged:
•
Incorrect level (cross-connect)
•
Incorrect interval
•
Incorrect MA-ID (cross-connect)
•
Local MAC address received (loop)
•
Local MEP-ID received (mis-config)
•
Invalid source MAC received
•
RDI received
Task ID
OperationsTask ID
read, writeethernet-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
264
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
log continuity-check errors
To Next Page
Loading...
