fdl
To enable or disable the transmission of performance reports through Facility Data Link (FDL) for a T1
channel on the channelized T3 interface, use the fdl command in T1 configuration mode. To return to the
default state of performance reporting, use the no form of this command.
fdl {ansi| att} {enable| disable}
no fdl {ansi| att} {enable| disable}
Syntax Description
Specifies the transmission of ANSI T1.403 once-per-second performance reports.ansi
Specifies the transmission of AT&T TR54016 once-per-second performance reports.att
Enables transmission of the specified performance reports.enable
Disables transmission of the specified performance reports. The default is disable.disable
Command Default
The transmission of ANSI T1.403 and AT&T TR54016 performance reports through FDL are disabled.
Command Modes
T1 configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The fdl command applies only to T1 lines and can be used only if the T1 framing type is Extended Super
Frame (ESF).
To display the performance report information, use the show controllers t1 command.
Task ID
OperationsTask ID
read, writesonet-sdh
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1000
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
fdl
To Next Page
Loading...
Need help?
General
