Cisco ASR 9000 Series Command Reference Guide

debug ethernet cfm packets
To log debug messages about CFM packets that are sent or received by the Ethernet connectivity fault
management (CFM) process, use the debug ethernet cfm packets command in EXEC mode.
debug ethernet cfm packets [domain domain-name [service service-name [mep-id mep-id]]] [interface
type interface-path-id [domain domain-name]] [packet-type {ccm| linktrace| loopback}] [remote
mac-address mac-address] [remote mep-id mep-id] [sent| received] [brief| full| hexdump]debug ethernet
cfm packets [domain domain-name [service service-name [mep-id mep-id]]] [interface type interface-path-id
[domain domain-name]] [packet-type {ais| ccm| delay-measurement| linktrace| loopback}] [remote
mac-address mac-address] [remote mep-id mep-id] [sent| received] [brief| full| hexdump]
Syntax Description
(Optional) Filters packets for display by the specified CFM maintenance
domain, where domain-name is a string of up to 80 characters.
domain domain-name
(Optional) Filters packets for display by the specified service name, where
service-name is a string of up to 80 characters.
service service-name
(Optional) Filters packets for display by the specified maintenance end point
(MEP) ID number. The range for MEP ID numbers is 1 to 8191.
mep-id mep-id
(Optional) Filters packets for display by the specified physical interface or
virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface type
interface-path-id
(Optional) Filters packets for display by the specified packet type. The
following packet types are valid:
•
ais
•
ccm
•
delay-measurement
•
linktrace
•
loopback
packet-type
(Optional) Filters packets for display by the specified MAC address.remote mac-address
mac-address
(Optional) Filters packets for display by the remote MEP properties.
remote mep-id mep-id
(Optional) Displays only sent packets.sent
(Optional) Displays only received packets.received
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
196
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
debug ethernet cfm packets

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model