Cisco ASR 9000 Series - SONET Controller Commands on the Cisco ASR 9000 Series Router

SONET Controller Commands on the
Cisco ASR 9000 Series Router
This module provides command line interface (CLI) commands for configuring SONET operation, using
Layer 1 SONET transport technology, on the Cisco ASR 9000 Series Router.
The configuration of the SONET controller includes SONET Automatic Protection Switch (APS), which is
a feature offering recovery from fiber (external) or equipment (interface and internal) failures at the SONET
line layer. You must configure a SONET controller before you can configure a Packet-over-SONET/SDH
(POS) interface or a serial interface.
All SONET-related configurations of a SONET-based physical port are grouped under the SONET controller
configuration submode. The SONET path-related configuration commands are grouped under the SONET
path submode.
•
ais-shut (SONET), page 835
•
ais-shut (SONET path), page 837
•
aps group, page 839
•
aps group (global), page 842
•
au, page 844
•
authenticate (PGP), page 846
•
b3-ber-prdi, page 848
•
channel local, page 849
•
channel remote, page 851
•
clear counters sonet, page 853
•
clock source (SONET), page 855
•
controller (SONET), page 857
•
delay clear, page 859
•
delay trigger, page 861
•
down-when-looped, page 863
•
framing (SONET), page 864
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
833