Cisco ASR 9000 Series - Mlacp Iccp-Group

mlacp iccp-group
To configure ICCP redundancy group for a bundle, use the mlacp iccp-group command in bundle interface
configuration mode. To return to the default value, use the no form of this command.
mlacp iccp-group group-id
no mlacp iccp-group group-id
Syntax Description
Specifies the ICCP redundancy group in which the bundle should operate. The
group-id value ranges between 1-4294967295.
group-id
Command Default
The bundle behaves as a single chassis LAG.
Command Modes
Bundle interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeBundle
Examples
The following example shows how to configure an ICCP redundancy group for a bundle:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 30
RP/0/RSP0/CPU0:router(config-if)# mlacp iccp-group 200
RP/0/RSP0/CPU0:router(config-if)#
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
610
Link Bundling Commands on the Cisco ASR 9000 Series Router
mlacp iccp-group