Cisco ASR 9000 Series Command Reference Guide

refresh rtp
To enable the configured context refresh settings for RTP packets, use the refresh rtp command in IPHC
profile configuration mode. To disable context refresh settings for RTP packets, use the no form of this
command.
refresh rtp
no refresh rtp
Syntax Description
This command has no keywords or arguments.
Command Default
By default, refresh RTP is disabled and only the first packet in the flow is sent as a ‘full-header’ packet.
Command Modes
IPHC profile configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeip-services
Examples
The following example shows how to enable the configured refresh settings for RTP packets:
RP/0/RSP0/CPU0:router(config)# config
RP/0/RSP0/CPU0:router(config)# iphc profile Profile_1 type iphc
RP/0/RSP0/CPU0:router(config-iphc-profile)# refresh rtp
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
805
Serial Interface Commands on the Cisco ASR 9000 Series Router
refresh rtp

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model