Cisco ASR 9000 Series Command Reference Guide

You can configure the Ethernet SLA profile to use Y.1731 DMM frames. The restriction of 150 configured
Ethernet SLA operations for each CFM MEP is removed not only for profiles using DMM frames, but
also for profiles using the other supported Y.1731 frame types, such as loopback measurement and synthetic
loss measurement. For interoperability purposes, it is still possible to configure profiles to use DMM v0
frames. This is done by specifying a type of cfm-delay-measurement-v0 on the profile(SLA) command.
The limit of 150 configured operations for each CFM MEP still applies in this case.
Note
Task ID
OperationsTask ID
read, writeethernet-services
Examples
This example shows how to configure an SLA operation profile and enter the SLA profile configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet sla
RP/0/RSP0/CPU0:router(config-sla)# profile Prof1 type cfm-loopback
RP/0/RSP0/CPU0:router(config-sla-prof)#
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
302
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
profile (SLA)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model