Cisco ASR 9000 Series Command Reference Guide

delay clear (T1/E1)
To configure the amount of time before a T1 or E1 path delay trigger alarm is cleared, use the delay clear
command in T1 or E1 configuration mode. To return the command to its default setting, use the no form of
this command.
delay clear value
no delay clear value
Syntax Description
Value, in milliseconds, before a T1 path delay trigger alarm is cleared. The range is from
0 through 180000. The default is 10 seconds.
value
Command Default
The default is 10 seconds.
Command Modes
T1 configuration
E1 configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Support for E1 configuration mode was added.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to specify that T1 path delay trigger alarms should be cleared after 9000
seconds:
RP/0/RSP0/CPU0:router(config)# controller t1 0/4/2/0/1
RP/0/RSP0/CPU0:router(config-t1)#delay clear 9000
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
978
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
delay clear (T1/E1)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model