Cisco ASR 9000 Series Command Reference Guide

Ten GigE interfaces will not show egress statistics when loopback line is configured because the loopback
is closed at the interface controller level, before the Network Processor (NP). But on One GigE interfaces
the line loopback is closed in the NP.
Note
Task ID
OperationTask ID
read, writeinterface
Examples
This example shows how to enter interface configuration mode for a Ten Gigabit Ethernet interface:
RP/0/RSP0/CPU0:router(config)# interface TenGigE 0/4/0/0
RP/0/RSP0/CPU0:router(config-if)#
Related Commands
DescriptionCommand
Displays statistics for all interfaces configured on the router or for
a specific node.
show interfaces, on page 516
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
86
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
interface (Ethernet)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model