Cisco ASR 9000 Series - Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference

The local and peer lid names do not have to be unique. However, regardless of whether you create a lid name
using the frame-relay multilink lid command or the systems uses the default name for the bundle link, each
link within a bundle must have a unique name. If the same name is used by different links in the same bundle,
the bundles will flap indefinitely.
Task ID
OperationsTask ID
read, writefr
Examples
The following example shows how to configure the lid name as ‘BL1’ for the serial interface 0/3/1/0:
RP/0/RSP0/CPU0:router(config)# interface serial 0/3/1/0
RP/0/RSP0/CPU0:router(config-if)# frame-relay multilink lid BL1
Related Commands
DescriptionCommand
Enables Frame Relay encapsulation.encapsulation frame-relay, on page 429
Assigns a BID name to a multilink Frame Relay
bundle.
frame-relay multilink bid, on page 452
Displays frame relay information for the LMI.show frame-relay lmi-info, on page 465
Disables an interface.shutdown (interface)
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
457
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay multilink lid