Cisco ASR 9000 Series Command Reference Guide

•
Which members are used for a specified source/destination address pair, such as 10.10.10.1 20.20.20.1
•
The destination IP address for a specified source IP address on a specified member.
• The load balancing distribution–how many times the members of a bundle are used for a specified range
of IP addresses.
The bundle-hash command does not display all possible IP addresses in an entire series. It stops displaying
addresses after all the addresses for all the members of the bundle have been displayed once.
The bundle-hash command is not applicable to multicast traffic and only applicable to unicast traffic.
The bundle-hash command invokes a utility that initially prompts you to select some options. Based on the
options you select, the utility prompts you more options to select. The initial options to select are as follows:
•
L3/3-tuple or L4/7-tuple
•
Single pair or Range
•
IPv4 or IPv6
The bundle-hash command utility prompts you for these options as follows:
•
Specify load-balance configuration (L3/3-tuple or L4/7-tuple) (L3,L4):
•
Single SA/DA pair (IPv4,IPv6) or range (IPv4 only): S/R [S]:
•
Enter bundle type IP V4 (1) or IP V6 (2):
•
Enter source IP V4 address:
•
Enter destination IP V4 address:
•
Compute destination address set for all members? [y/n]:
•
Enter subnet prefix for destination address set:
•
Enter bundle IP V4 address [10.10.10.10]:
You may also be prompted to make further option choices depending on your selections.
You can use the show bundle command to get IP address information.
Table 38: bundle-hash Command Options, on page 568 provides a general summary of the options and the
information you need to provide for each selected option. The actual information that you need to provide
depends on the selections you make and may vary from the information provided in Table 38: bundle-hash
Command Options, on page 568.
Table 38: bundle-hash Command Options
Information You Need to ProvideOption
L3 information:
•
Source IP address
•
Destination IP address
•
Destination subnet prefix
•
Bundle IP address
L3/3-tuple
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
568
Link Bundling Commands on the Cisco ASR 9000 Series Router
bundle-hash

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model