Cisco ASR 9000 Series Command Reference Guide

statistics measure
To enable the collection of Ethernet Service Level Agreement (SLA) statistics, and enter the SLA profile
statistics configuration mode, use the statistics measure command in SLA profile configuration mode. To
disable statistics collection, use the no form of this command.
statistics measure {one-way-delay-ds| one-way-delay-sd| one-way-jitter-ds| one-way-jitter-sd|
round-trip-delay| round-trip-jitter| one-way-loss-sd| one-way-loss-ds}
no statistics measure {one-way-delay-ds| one-way-delay-sd| one-way-jitter-ds| one-way-jitter-sd|
round-trip-delay| round-trip-jitter| one-way-loss-sd| one-way-loss-ds}
Syntax Description
(CFM delay measurement profile type only) Enables the collection of statistics
that measure delay in one direction, from destination to source.
one-way-delay-ds
(CFM delay measurement profile type only) Enables the collection of statistics
that measure delay in one direction, from source to destination.
one-way-delay-sd
(CFM delay measurement profile type only) Enables the collection of statistics
that measure delay variance in one direction, from destination to source.
one-way-jitter-ds
(CFM delay measurement profile type only) Enables the collection of statistics
that measure delay variance in one direction, from source to destination.
one-way-jitter-sd
(CFM delay measurement and CFM loopback profile types only) Enables the
collection of statistics that measure the delay in the round trip of a packet.
round-trip-delay
(CFM delay measurement and CFM loopback profile types only) Enables the
collection of statistics that measure the amount of delay variance in the round
trip of a packet.
round-trip-jitter
(CFM loss measurement profile type only) Enables the collection of statistics
that measure the synthetic loss in one direction, from source to destination.
one-way-loss-sd
(CFM loss measurement profile type only) Enables the collection of statistics
that measure the synthetic loss in one direction, from destination to source.
one-way-loss-ds
Command Default
No statistics are collected
Command Modes
SLA profile configuration (config-sla-prof)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
402
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
statistics measure

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model