Cisco ASR 9000 Series - Transmit-Delay

transmit-delay
To specify a number of flag sequences to be inserted between the packets, use the transmit-delay command
in POS configuration mode. To restore the default, use the no form of this command.
transmit-delay microseconds
no transmit-delay microseconds
Syntax Description
Number of microseconds of minimum delay after sending a packet. Range is
from 0 to 1023. Default is 0 (disabled).
microseconds
Command Default
microseconds = 0 (disabled)
Command Modes
POS configuration
Command History
ModificationsReleases
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writepos-dpt
Examples
In the following example, a delay of 2 microseconds is specified on POS interface 0/1/0/2:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface POS 0/1/0/2
RP/0/RSP0/CPU0:router(config-if)# pos
RP/0/RSP0/CPU0:router(config-if-pos)# transmit-delay 2
In the following example, the transmit delay on POS interface 0/1/0/2 is disabled:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface POS 0/1/0/2
RP/0/RSP0/CPU0:router(config-if)# pos
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
707
Packet-over-SONET Interface Commands on the Cisco ASR 9000 Series Router
transmit-delay