DescriptionField
Number of interfaces of the specified type that are in
the “Admin Down” state.
Admin Down
The following example shows how to display brief information for a specific POS interface:
RP/0/RSP0/CPU0:router# show interfaces pos 0/2/0/0 brief
Intf Intf LineP Encap MTU BW
Name State State Type (byte) (Kbps)
-------------------------------------------------------------------------------
PO0/2/0/0 admin-down admin-down HDLC 4474 2488320
Table 48: show interfaces pos Field Descriptions
DescriptionField
Interface identifier, in the type*rack/slot/module/port
notation.
Intf Name
Indicates whether the interface is in the admin-up or
admin down state.
Intf State
Line protocol state.LineP State
Encapsulation type for the specified interface. Can
be HDLC or PPP.
Encap Type
Maximum transmission unit (MTU) value configured
for the specified interface, in bytes.
MTU (byte)
Bandwidth of the interface, in kbps.BW (Kbps)
Related Commands
DescriptionCommand
Displays information on the POS controllers.show controllers pos, on page 900
Displays information about the operational status of SONET
layers.
show controllers sonet, on page 906
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
706
Packet-over-SONET Interface Commands on the Cisco ASR 9000 Series Router
show interfaces pos
To Next Page
Loading...
Need help?
General
