frame-relay multilink lid
To create a name for a Frame Relay multilink bundle link, use the frame-relay multilink lid command in
interface configuration mode. To reset the name to the default, use the no form of this command.
frame-relay multilink lid link-id name
no frame-relay multilink lid
Syntax Description
Specifies the name for the Frame Relay multilink bundle link. The link identifier
(lid) name can be up to 49 characters long.
link-id name
Command Default
The name of the physical interface, for example, Serial 0/3/0/0/1/2:0, is used as the lid.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The frame-relay multilink lid command is supported only on serial interfaces. The frame-relay multilink
lid command is not supported on Packet-over-SONET/SDH (POS) or multilink frame relay interfaces.
Note
The frame-relay multilink lid command can be configured only on bundle link interfaces that have been
associated with a bundle using the encapsulation frame-relay mfr command.
You can enter the frame-relay multilink lid command at any time without affecting the current state of
the interface; however, the link identifier name does not go into effect until the interface has gone from
the down state to the up state. One way to bring the interface down and back up again is by using the
shutdown and no shutdown commands in interface configuration mode.
Note
Thelid name is used to identify the bundle link to peer devices and to enable the devices to identify which
bundle links are associated with which bundles. The lid name can also be assigned when the bundle link is
created using the encapsulation frame-relay mfr command with the name argument. If a lid name is not
assigned, the default lid is the name of the physical interface.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
456
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay multilink lid
To Next Page
Loading...
Need help?
General
