Cisco ASR 9000 Series Command Reference Guide

mlacp port-priority
To set the priority for all member links, use the mlacp port-priority command in bundle interface configuration
mode. To return to the default value, use the no form of this command.
mlacp port-priority priority
no mlacp port-priority priority
Syntax Description
Specifies the priority for member ports. The priority value ranges between 1-65535.
A lower value indicates higher priority.
priority
Command Default
No default behavior or values
Command Modes
Bundle interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeBundle
Examples
This example shows how to set the priority for all member links:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 30
RP/0/RSP0/CPU0:router(config-if)# mlacp port-priority 20
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
612
Link Bundling Commands on the Cisco ASR 9000 Series Router
mlacp port-priority

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model