Cisco ASR 9000 Series Command Reference Guide

destination pseudowire
To direct mirrored traffic to a pseudowire, use the destination pseudowire command in monitor session
configuration mode. To remove the pseudowire designation, use the no form of this command.
destination pseudowire
no destination pseudowire
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
Monitor session configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
Use the destination pseudowire command to direct the mirrored traffic to a pseudowire. A network analyzer
in a central location can then be used to monitor the traffic. Use the monitor session command to define the
exact pseudowire to which the monitored traffic should be replicated.
Examples
This example shows how to configure a monitoring port for a traffic mirroring session:
RP/0/RP0/CPU0:router(config)# monitor-session mon1
RP/0/RSP0/CPU0:router(config-mon)# destination pseudowire
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1080
Traffic Mirroring Commands on the Cisco ASR 9000 Series Router
destination pseudowire

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model