mlacp connect
To specify configuration options for connecting to mLACP peers, use the mlacp connect command in the
redundancy ICCP group configuration mode. To disable this feature, use the no form of this command.
mlacp connect timeout seconds
no mlacp connect timeout seconds
Syntax Description
Specifies the time to wait before assuming mLACP peer is down.timeout
Number of seconds to wait before assuming the mLACP peer is down.
seconds
Command Default
No default behavior or values
Command Modes
Redundancy ICCP group configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writebundle
Examples
This example shows how to specify configuration options for connecting to mLACP peers:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# redundancy iccp group 10
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)# mlacp connect timeout 100
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)#
Related Commands
Configures ICCP parameters.redundancy iccp group
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
608
Link Bundling Commands on the Cisco ASR 9000 Series Router
mlacp connect
To Next Page
Loading...
Need help?
General
