ppp max-terminate
To configure the maximum number of terminate requests (TermReqs) to send without reply before closing
down the Link Control Protocol (LCP) or Network Control Protocol (NCP), use the ppp max-terminate
command in interface configuration mode. To disable the maximum number of TermReqs and return to the
default, use the no form of this command.
ppp max-terminate number
no ppp max-terminate
Command Default
number: 2
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeppp
Examples
In the following example, a maximum of five TermReqs are specified to be sent before terminating and closing
LCP or NCP:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface POS 0/3/0/1
RP/0/RSP0/CPU0:router(config-if)# encapsulation ppp
RP/0/RSP0/CPU0:router(config-if)# ppp max-terminate 5
Related Commands
DescriptionCommand
Specifies the maximum number of configure requests to attempt
(without response) before stopping the requests.
ppp max-configure , on page 732
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
736
PPP Commands onthe Cisco ASR 9000 Series Router
ppp max-terminate
To Next Page
Loading...
Need help?
General
