Cisco ASR 9000 Series Command Reference Guide

interface multilink
To configure a multilink interface and enter multilink interface configuration mode, use the interface multilink
command in global configuration mode. To delete the interface configuration, use the no form of this command.
To return to the default state, use the no form of this command.
interface multilink interface-path-id[.subinterface{l2transport| point-to-point}]
no interface multilink interface-path-id[.subinterface{l2transport| point-to-point}]
Syntax Description
Physical interface or virtual interface followed by the optional subinterface
path ID. Naming notation is interface-path-id.subinterface.The period in front
of the subinterface value is required as part of the notation.
For more information about the syntax for the router, use the question mark
(?) online help function.
interface-path-id [.
subinterface]
Configures interface to function as one endpoint on a Layer 2 link.l2transport
Configures interface to function as one endpoint on a point-to-point link.point-to-point
Command Default
No interfaces are configured.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
The subinterface argument and the keywords l2transport and
point-to-point were introduced.
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The subinterface argument and keywords l2transport and po in t-to-point are only applicable if frame relay
encapsulation is enabled using the encapsulation frame-relay command.
Task ID
OperationsTask ID
read, writeinterface
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
680
Multilink Commands on the Cisco ASR 9000 Series Router
interface multilink

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model