Cisco ASR 9000 Series Command Reference Guide

interface bvi
To create a bridge-group virtual interface (BVI), use the interface bvi command in global configuration mode.
To delete the BVI, use the no form of this command.
interface bvi identifier
no interface bvi identifier
Syntax Description
Number for the BVI interface from 1 to 65535.
identifier
Command Default
No BVI interface is configured.
Command Modes
Global configuration (config)
Command History
ModificationRelease
This command was introduced.Release 4.0.1
Usage Guidelines
The BVI is a virtual interface within the router that acts like a normal routed interface. The BVI does not
support bridging itself, but acts as a gateway for the corresponding bridge-domain to a routed interface within
the router.
Aside from supporting a configurable MAC address, a BVI supports only Layer 3 attributes, and has the
following characteristics:
•
Uses a MAC address taken from the local chassis MAC address pool, unless overridden at the BVI
interface.
•
Is configured as an interface type using the interface bvi command and uses an IPv4 or IPv6 address
that is in the same subnet as the hosts on the segments of the bridged domain. The BVI also supports
secondary addresses.
•
The BVI identifier is independent of the bridge-domain identifier. These identifiers do not need to
correlate like they do in Cisco IOS software.
•
Is associated to a bridge group using the routed interface bvi command.
•
The following interface commands are supported on a BVI:
•
arp purge-delay
•
arp timeout
•
bandwidth (The default is 10 Gbps and is used as the cost metric for routing protocols for the
BVI.)
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
554
Integrated Routing and Bridging Commands on the Cisco ASR 9000 Series Router
interface bvi

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model