pm fec report enable
To enable Threshold Crossing Alert (TCA) generation for FEC, use the pm fec report enable command in
DWDM configuration mode. To disable TCAs, use the no form of this command.
pm {15-min| 24-hour} fec report {ec-bits| uc-words} enable
no pm {15-min| 24-hour} fec report {ec-bits| uc-words} enable
Syntax Description
Configures the TCA generation for 15-minute intervals.15-min
Configures TCA generation for 24-hour intervals.24-hour
Bit errors corrected (BIEC). Indicates the number of bit errors corrected in the
DWDM trunk line during the performance monitoring time interval.
ec-bits
Uncorrectable words. This is the number of uncorrectable words detected in the
DWDM trunk line during the performance monitoring time interval.
uc-words
Command Default
TCA is not enabled.
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To display FEC performance measurement information, use the show controller dwdm pm fec command.
Task ID
OperationsTask ID
read, writedwdm
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
32
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
pm fec report enable
To Next Page
Loading...
