show controllers t3
To display information about the T3 links and hardware and software drivers for the T3 controller, use the
show controllers t3 command in EXEC mode.
show controllers t3 interface-path-id [all| bert| brief| internal-state| tabular]
Syntax Description
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
Displays all information for the controllers.all
Displays internal T3 bit error rate test results.bert
Displays summary information for the controller.brief
Displays internal T3 state information.internal-state
Displays T3 controller information in tabular format.tabular
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For the interface-path-id argument, use the following guidelines:
•
When specifying a T3 controller, the naming notation is rack/slot/module/port/T3num. The slash between
values is required as part of the notation. An explanation of each component of the naming notation is
as follows:
◦ rack—Chassis number of the rack.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1054
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
show controllers t3
To Next Page
Loading...
Need help?
General
