Cisco ASR 9000 Series Command Reference Guide

Changing the size of the buckets for a given metric clears all stored data for that metric. All existing
buckets are deleted and new buckets are created.
Note
Task ID
OperationsTask ID
read, writeethernet-services
Examples
This example shows how to configure the size of the buckets in which statistics are collected.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet sla
RP/0/RSP0/CPU0:router(config-sla)# profile Prof1 type cfm-loopback
RP/0/RSP0/CPU0:router(config-sla-prof)# statistics measure round-trip-delay
RP/0/RSP0/CPU0:router(config-sla-prof-stat-cfg)# buckets size 100 per-probe
Related Commands
DescriptionCommand
Configures the number of buckets to store in memory.buckets archive, on page 161
Enters SLA profile probe configuration mode.probe, on page 298
schedule (SLA), on page 307
Configures the number and timing of packets sent by a probe
in an operations profile.
send (SLA), on page 311
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
164
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
buckets size

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model