Cisco ASR 9000 Series Command Reference Guide

(Optional) Specifies that the probe
begins as soon as you enter the
command. This is the default.
schedule now
(Optional) Specifies a specific time
at which to start the probe in
24-hour notation.
schedule at hh:mm:ss
(Optional) Number in the range 1
to 31 of the day of the month on
which to start the probe.
day
(Optional) Name of the month (full
word in English) in which to start
the probe.
month
(Optional) Year (fully specified as
4 digits) in which to start the probe.
year
(Optional) Specifies a relative time,
as a number of seconds, minutes or
hours from the current time, at
which to start the probe, where
number is in the following ranges:
•
1 to 3600 seconds
•
1 to 1440 minutes
•
1 to 24 hours
schedule in number {seconds | minutes | hours}
(Optional) Specifies the length of
the probe as a number of seconds,
minutes, or hours, where number
is in the following ranges:
•
1 to 3600 seconds
•
1 to 1440 minutes
•
1 to 24 hours
The duration should not
exceed the interval
specified by the repeat
every option.
Note
for duration {seconds | minutes | hours}
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
236
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet sla on-demand operation type cfm-loopback probe

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model