Cisco ASR 9000 Series Command Reference Guide

DescriptionField
The OAM protocol from which the EVC status and
type are derived. Possible values are either "CFM"
or "None."
OAM Protocol:
Name of the CFM domain for this EVC.CFM Domain:
Name of the CFM service for this EVC.CFM Service:
Number of configured or expected remote UNIs (x)
and the number of active remote UNIs (y) within the
EVC.
Remote UNI Count: Configured = x, Active = y
ID of each remote UNI, including both configured
and active remote UNIs where these two sets are not
identical. If the number of configured and active
remote UNIs is zero, no table is displayed.
Where no ID is configured for a remote UNI
using the ethernet uni id command, then
the CFM remote MEP ID is displayed, for
example, "<Remote UNI Reference Id: x>"
Note
Remote UNI Id:
Status of each remote UNI, with the following
possible values: "Up," "Down," "Admin Down,"
"Unreachable (a configured remote UNI is not active
or missing)," or "Unknown (a remote UNI is active
but not reporting its status)."
Status
Related Commands
DescriptionCommand
Clears Ethernet LMI statistics on one or all interfaces.clear ethernet lmi interfaces, on page 175
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
362
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
show ethernet lmi interfaces

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model