clear iphc ipv4
To clear all Real Time Protocol (RTP) and Transport Control Protocol (TCP) statistics for IP header compression
(IPHC) packets sent and received on an interface, use the clear iphc ipv4 command in EXEC mode.
clear iphc ipv4 {interface {serial| multilink} interface-path-id| location node-id}
Syntax Description
Specifies the interface to be configured, by type and the interface-path-id
argument.
interface
Specifies a serial network interface.serial
Specifies a multilink network interface.multilink
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
Specifies the interface to be configured by its node-id.
location
Fully qualified path of the node in the rack/slot/module notation.node-id
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The clear counters command also clears the IPHC statistics for all the interfaces.Note
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
777
Serial Interface Commands on the Cisco ASR 9000 Series Router
clear iphc ipv4
To Next Page
Loading...
Need help?
General
